220V COB LED Strip in 25 m Reel, Continuous Light Line

In layout lighting, the dotted effect of a spaced LED strip is immediately visible on reflective surfaces and shallow diffusers. COB (Chip On Board) technology, which distributes 296 LEDs per meter under a continuous phosphor coating, eliminates this effect and allows for low-profile channels without visible halos. The power supply is directly 220V, with no driver to install or size, simplifying the design and shortening installation time. The 25 m reel can be cut at the designated cutting marks, and its IP65 rating allows use in damp rooms as well as sheltered outdoor areas.

Technical Details

• 10W per meter, totaling 250W on the 25 m reel
• 296 LEDs per meter using COB technology
• Light output of approximately 800 lm per meter, efficiency of 80 lm/W
• Direct 220-240V power supply, no driver needed
• Maximum length of 50 m in series
• IP65 protection rating, cuttable at designated marks
• Operating range from -20°C to +40°C

Features

• Continuous light line, no visible dots even in shallow profiles
• No driver to size or install within the structure
• No circuit dependency: failure of one segment does not turn off the entire line
• Flexibility to follow cornices, returns, and curves
• Cuttable at designated marks to adjust layout

Installation

Unroll the strip along the support, secure it with clips or in an aluminum profile, then connect the end to 220-240V. Cutting must be done exclusively at the designated marks, and the free end must be sealed with an end cap to maintain IP65 protection. Observe the 50 m maximum length in series. Work must be done with power off.

Where to Use This COB LED Strip?

• Store layouts: gondolas, shelving units, and display cases
• Cornices, soffits, and indirect lighting in commercial spaces
• Reception counters, banks, and welcome areas
• Step noses, handrails, and traffic guidance
• Professional kitchens and work surfaces in damp zones