Relamping study

What your lighting costs you, and what it would cost with LED.

Enter your installed base and the figure updates with every keystroke. No sign-up needed to see your result, and the partner discount is included from the first estimate.

  • Partner discount up to -20 %
  • Devis sous 24 h
  • 5-year warranty on the Pro+ range
  • Shipped in 24-48 h
What you get
  • An instant figure, no sign-up or email required.
  • Pricing based on real products, with your partner discount applied.
  • A PDF in your name, ready to send to management or a landlord.

Two minutes, four steps, and you can go back at any time.

Your current installation

Choose the closest profile and adjust your figures: the result updates as you type.

Typical profile

points
W

Per luminaire, including ballast.

W

For comparable luminous flux, not equal wattage.

h / day
j / an
€ incl. VAT

All-inclusive price. Switch to excl. VAT to enter the figure from your bill.

This figure does not yet tell you whether the project is cost-effective.

The study uses your values and adds real products, your partner discount, avoided maintenance and the payback month.

Several sites, or more than 300 light points?

Beyond a certain volume, pricing from plans is more accurate than a simulation. A sales representative will review your plans, your surveys and your partner level.

Talk to a sales representative

Trois parcs, trois arbitrages

Typical configurations, costed using the simulator method. Your own figures will replace these in under two minutes.

Logistics warehouse, 4,200 m²

€14,800

saved per year

Existing
86 sodium 400 W
Replaced by
UFO high bay 150 W
Operation
14 h × 300 d
Payback
11 months
Office floor, 1,800 m²

€3,900

saved per year

Existing
240 T8 58 W tubes
Replaced by
UGR<19 36 W panel
Operation
10 h × 230 d
Payback
19 months
Underground car park, 180 spaces

€5,200

saved per year

Existing
96 T8 36 W battens
Replaced by
IP65 batten with sensor
Operation
24 h × 365 d
Payback
14 months

What the study adds to the figure above

The energy calculation is the easy part. What gets a budget approved is everything else.

Equipment

Products, not watts

Catalogue products suited to each room, with their price and the annual saving shown product by product.

Price

Your partner discount applied

The pricing reflects your level and the order value, from -5% to -20%. It is the price you will pay, not the catalogue price.

Operation

The maintenance you eliminate

Lamp and ballast replacements avoided over time, including labour and aerial lift, spread over the chosen period.

Decision

The month it pays for itself

Payback curve, three electricity price scenarios, net gain at 5 and 10 years. All in a PDF.

Method

Our assumptions are shown, and can be changed

A calculator that hides its maths is useless in front of a finance department. Everything that goes into the figure is visible, and everything can be adjusted in the study.

The calculation used, line by line: points × (current watts − LED watts) ÷ 1,000 × annual hours × kWh price. No additional correction factor is applied.

Default kWh price
0.240 € incl. VAT
CO₂ content of electricity
60 g / kWh
LED lifespan used
50 000 h
Maintenance period
10 years
Installation cost, per point
5 to 18 € depending on type
Scope
like-for-like relamping
Out of scope
electrical engineering, WEEE

Questions we are asked before getting started

Does the price shown include my partner discount?

Yes, from the costed study onwards. The discount is based on your partnership level and the batch amount, from -5 % to -20 %. If you do not have a trade account yet, the study applies the entry level.

Is the study a quote?

No. It is an estimate to help set a budget and make decisions. Prices are catalogue prices on the date of issue, and the installation cost is indicative. A firm quote goes through a sales rep, within 24 h.

I don't know the wattage of my current luminaires.

Start from a typical profile: it fills in a consistent value for most installations. Otherwise, the wattage is marked on the luminaire or the tube, and for a fluorescent tube you need to add about 10 W of ballast to the stated value.

Is installation included?

It is estimated in the study, at €5 to €18 per point depending on the type of luminaire, based on like-for-like replacement with no new cabling. Silumen supplies the equipment; installation is carried out by you or your installer.

What if my installation is spread across several sites?

The study accepts several spaces with different operating hours. Beyond three sites or 300 points, pricing from plans gives a much more accurate result, and a sales rep handles it.

What warranty comes with the products offered?

Five years on the Silumen Pro+ range, with datasheets and photometric test reports available for each product.

A figure in two minutes, a firm quote in 24 hours

Start with the estimate, or go straight to a sales rep if your project is already defined.

01 70 61 36 80, Monday to Friday. Reply within 24 h.

0 € TTC / anestimated saving