100 m Tunnel LED Strip Kit — 2 Connected 50 m Strips + 220V Power Supply

For fitting long, continuous runs, this kit combines two 50 m strips connected end to end and a single mains power supply. Powered directly by 220V, it eliminates multiple low-voltage transformers and limits connection points over 100 metres - an advantage for extended façades, building perimeters and marking areas. The IP65 PVC sleeve protects the SMD2835 chips in damp conditions and sheltered outdoor areas, providing a continuous line of 120 LEDs per metre. Covering 100 m from a single power supply point is exceptional for this type of strip, as most are limited to just a few metres.

Technical details

• Kit with 2 x 50 m strips + 1 mains power supply - 100 m total
• Power: 9W per metre - 450W (alternating 1 m lit / 1 m without LEDs)
• Total luminous flux: 30100 lm - 120 LEDs per metre - SMD2835 chips - CRI Ra 90
• Direct 220-240V, 50-60Hz power supply - alternating current (AC)
• IP65 protection rating (dust-tight and protected against water jets)
• PVC sleeve - 18 x 7 mm profile - connectable up to 250 m
• Can be cut every 1 m - lifespan ~20,000 h - 2-year warranty

Features

• 2 strips connected as one continuous run: fewer joints on large perimeters
• Direct 220V power supply without a low-voltage transformer
• IP65 waterproofing for sheltered outdoor areas and damp indoor spaces
• Can be cut every 1 m at the marked points - CRI Ra 90

Installation

Unroll and secure the 2 strips along the route, connect them end to end, then connect the supplied 220V power supply; seal the free end with an end cap. For long runs, observe the maximum power permitted per power supply point as specified by the manufacturer and plan multiple injection points if needed. Connect with the power off.

Where can you use this strip?

• Long façades and building perimeters
• Marking parking lots, ramps and traffic routes
• Large sheltered outdoor areas
• Industrial sites, warehouses and technical areas