200 m tunnel LED strip kit — 4 connected 50 m strips + 220V power supply

This kit covers very large areas with 4 50 m strips connected end to end and a single mains power supply. Direct 220V power eliminates multiple low-voltage transformers and minimizes connections over 200 meters, making it ideal for industrial facades, parking lot marking, and long access roads. The IP65 PVC sleeve protects the SMD2835 chips in damp environments and sheltered outdoor areas, providing a continuous line of 120 LEDs per meter. Lighting 200 m from a single point is exceptional for this type of strip.

Technical details

• Kit of 4 50 m strips + 1 mains power supply — 200 m total
• Power: 9W per meter — 900W (alternating 1 m illuminated / 1 m without LEDs)
• Total luminous flux: 60200 lm — 120 LEDs per meter — SMD2835 chips — CRI Ra 90
• Direct 220-240V power, 50-60Hz — alternating current (AC)
• IP65 protection rating (dust-tight and protected against water jets)
• PVC sleeve — 18 x 7 mm profile — connectable up to 250 m
• Can be cut every 1 m — lifespan ~20,000h — 2-year warranty

Features

• 4 strips connected in a single run: fewer joints across large areas
• Direct 220V power without a low-voltage transformer
• IP65 waterproofing for sheltered outdoor areas and damp rooms
• Can be cut every 1 m at the marked points — CRI Ra 90

Installation

Unroll and secure the 4 strips along the route, connect them end to end, then connect the supplied 220V power supply; seal the free end with an end cap. For long runs, observe the manufacturer's maximum permitted power per power supply point and provide multiple injection points if necessary. Make connections with the power off.

Where can you use this strip?

• Long facades and building perimeters
• Marking parking lots, ramps, and access roads
• Large sheltered outdoor areas
• Industrial sites, warehouses, and technical areas