220V LED Tunnel Strip in 50 m Coil, Up to 250 m in Series

The 50 m coil halves the number of joints on the same linear run compared to short packaging: fewer weak points and less connection time on an underground structure or parking lot. The principle remains the same — end-to-end chaining up to 250 m on a single 220V power supply, without a driver or power cable to pull — with an alternating pattern of 1 m equipped and 1 m without LEDs that spreads the lighting without increasing the installed power. The UV-resistant IP65 PVC sheath withstands moisture, dust, and sun exposure on exterior parts.

Technical Details

• 50 m coil, chainable up to 250 m on a single power supply point
• Alternating 1 m lit / 1 m without LED along the entire length
• Direct 220-240V power supply, no driver or power block needed
• 9W per meter lit, totaling 234W for the full coil
• 120 LEDs per meter on equipped sections, Ra 90
• IP65 protection rating against rain and dust
• Cuttable every meter at designated marks
• Flexible and durable UV-resistant PVC sheath

Features

• Half as many joints as with short packaging on the same linear run
• Only one power supply point needed to cover up to 250 m
• No power boxes to install or maintain along the route
• Flexibility suitable for curves, returns, and structural reliefs
• Ra 90 for faithful rendering of markings and signage

Installation

Unroll the coil along the support, fix the strip with clips or in a profile, then connect the power end to 220-240V. Chain the coils end to end up to 250 m before connecting the entire run to the single power supply point. Cutting is only allowed at the designated marks, every meter; seal the free end with a final cap. Work must be done with power off.

Where to Use This LED Tunnel Strip?

• Tunnels, technical galleries, and long underground networks
• Covered parking lots, ramps, and traffic lanes
• Pathway and logistics dock marking
• Outdoor structures, cornices, and linear facades
• Temporary installations and construction site living quarters