5M 24V IP20 320LED/m Green COB LED Strip

On a commercial project site, green is used for both guidance and decoration. This 5-meter reel delivers 8 W per meter at a density of 320 COB chips, producing a perfectly even green strip without the visible grain of standard SMD strips.

Technical details

• Density: 320 LED/m — COB (Chip On Board) technology
• 8 W/m — 40 W for the 5 m reel
• 5400 lm total, 1080 lm/m, 135 lm/W
• Incandescent equivalent: 400 W
• 24V DC (SELV) — requires a power supply transformer
• 120° beam angle — CRI Ra 80 — dimmable
• IP20 — dry indoor locations
• 500 x 0.79 cm — can be cut every 5 cm
• -20°C to +50°C — ~25000h — CE & RoHS — 2 years

Features

Because a monochrome green chip is more efficient than a filtered white LED, power consumption remains low while delivering high perceived brightness. The strip supports 24V PWM (Pulse Width Modulation) control and retains its hue even at very low dimming levels, making it suitable for continuous standby operation.

The flexible printed circuit bends lengthwise to follow a curve, stair nosing, or countertop edge, without restrictions at the cut points.

Installation

Switch off and lock out the main power supply. The 24V transformer must be sized with a 20% margin, meaning at least 48 W for the entire reel. Connect sections in parallel from the injection point to control voltage drop. Check the transformer’s protection rating for the location where it is installed.

Direct adhesion is suitable for smooth, clean surfaces; for intensive use or accessible areas, choose an aluminum profile with a diffuser to protect the circuit and improve heat dissipation.

Where can you use this LED strip?

Guidance lighting in a workshop or technical room, auxiliary lighting for a service staircase, highlighting a green wall in a reception hall, or zone signage in a logistics warehouse. For dry areas only: for damp or outdoor areas, specify at least IP65.