Waterproof LED batten with motion sensor and light, IP65, 36W, 110lm/w

In a parking garage lane, a storage aisle, or a basement corridor, the lights often run continuously due to a lack of suitable controls. This 120 cm batten combines three solutions to this problem: an integrated microwave sensor, an automatic shutoff timer, and a linkable design that lets you connect up to 8 units to a single power supply.

Technical details

Power supply: 220 - 240V, 50-60Hz. Power consumption: 36W for a luminous flux of 3960 lumens, giving a luminous efficacy of 110 lm/W. Neutral white, 4000K, color rendering index Ra 80, 120° beam angle. Dimensions: 120 x 5.8 x 6.4 cm. IP65 rating: dust-tight and protected against water jets, meeting the usual requirements for plant rooms and covered parking areas. IK08 mechanical resistance. Power factor greater than 0.9, which limits apparent power draw and ensures flicker-free operation, an important consideration under the NF EN 12464-1 standard for workplaces. Class II insulation, with no protective conductor.

Features

The microwave sensor detects movement through plastic covers from up to 3 meters away, with a dusk threshold of 13 to 18 lux. The light switches off 3 minutes after the last detection. Units can be linked using the supplied waterproof quick connector, with up to 8 battens connected in series. Rated lifetime: 50000 hours according to the L70B10 protocol. Supplied: 1 batten, 2 mounting brackets, 1 waterproof quick connector, 2 expansion plugs, 2 screws. 2-year warranty.

Installation

Isolate the power supply. Mark and drill two anchor points, with a spacing shorter than the luminaire, insert the wall plugs, then secure the brackets. Unscrew the waterproof connector, feed the power cable through the cable gland, connect the live wire (L) and neutral wire (N), then tighten the cap: tightening this connector is essential to maintaining the IP65 rating. Clip the batten onto its brackets, adjust it sideways, then restore power. Installation must be carried out by a qualified professional in accordance with NF C 15-100.

Where can you use this LED batten?

Covered parking areas, basements, cellars, workshops, warehouses, storage aisles, plant rooms, boiler rooms, industrial laundries, agricultural buildings, and passageways in dusty or damp environments. Its linkable design makes it an economical solution for lighting long runs from a single power feed, while the integrated sensor provides automatic lighting control for areas with intermittent occupancy.