360° Flexible LED Neon in 50 m Coil for Signs and Signage

The round profile with a Ø 14 mm diameter emits light all around its circumference: unlike a flat strip, the appearance remains consistent from any viewing angle, which is crucial for lettering seen from the street or an edge viewed at an angle. The flexible body allows you to form letters, logos, and tight curves without special tools, and the direct 220V power supply eliminates the need for a driver and its associated box — an important factor when the installation has no technical space. The 50 m coil covers an entire project, with cuts at marked points and IP65 waterproofing for outdoor use.

Technical Details

• 9W per meter, totaling 450W for the 50 m coil
• Round profile Ø 14 mm with 360° emission
• 240 LEDs per meter, approximately 580 lm per meter
• Color rendering index Ra 90
• Direct 220-240V power supply, no driver needed
• IP65 protection rating, suitable for outdoor use
• Cut at marked points only, operating range from -20°C to +40°C

Features

• 360° emission: consistent appearance from any viewing angle
• Low-radius bending for lettering, logos, and outlines
• Ra 90 color rendering, ideal for commercial facades and storefronts
• No driver or technical box required
• IP65 waterproof sheath for permanent outdoor exposure

Installation

Mark the layout on the surface, secure the neon with dedicated clips, tightening spacing on curves, then connect the end to 220-240V. Cutting is only allowed at the marked points; seal the free end with a final cap to maintain waterproofing. Work must be done with power off.

Where to Use This Flexible LED Neon?

• Signs, illuminated lettering, and logos for storefronts
• Commercial signage and facade identification
• Project outlines, handrails, and guardrails
• Terraces, pergolas, and outdoor setups for hospitality venues
• Event decorations and short-term scenography