Blue COB LED Strip, 50 m Roll Without Intermediate Junction

For perimeter marking or facade highlighting, each junction is a potential entry point for moisture and a possible failure during use. This 50 m roll corresponds to the product's maximum series length: the layout is done in one continuous piece, with no intermediate joints to seal or document. The 296 LEDs per meter using COB (Chip On Board) technology ensure a continuous blue light along the entire length, and the direct 220V power supply eliminates the need for a driver and its enclosure.

Technical Details

• Light color: monochrome blue
• 10W per meter, totaling 500W for the 50 m roll
• 296 LEDs per meter with COB technology
• Approximately 800 lm per meter, efficiency of 80 lm/W
• Direct 220-240V power supply, no driver required
• Maximum series length of 50 m, achieved with a single roll
• IP65 protection rating, cuttable at designated marks
• Operating range from -20°C to +40°C

Features

• 50 m continuous layout with no intermediate joints to seal
• Continuous blue light without dot effect on reflective surfaces
• No driver or power enclosure needed
• Flexible to follow corners and curves
• Approximate lifespan of 20,000 hours

Installation

Gradually unroll the strip along the support, fix the strip with clips or in an aluminum profile, then connect the end to 220-240V. Since the roll reaches the maximum series length, no additional chaining is possible. Cut only at the designated marks and seal the free end with a final end cap. Work must be done with power off.

Where to Use This Blue COB Strip?

• Long perimeter marking
• Highlighting facades and sheltered outdoor structures
• Large nighttime spaces and performance halls
• Technical scenographies and immersive routes
• Areas around pools and covered aquatic facilities