Blue COB LED Strip Sold by the Meter, Length Adjusted to Measurement

Supplementary markings and section repairs do not justify purchasing a full reel. Selling by the cut allows ordering the exact length measured on site, with no leftover stock or waste charged to the project. The product retains its features: 296 LEDs per meter using COB (Chip On Board) technology for a continuous blue light, direct 220V power supply without a driver, and an IP65 rating for damp or sheltered outdoor locations.

Technical Details

• Light color: monochrome blue
• 10W per linear meter, approximately 800 lm per meter
• 296 LEDs per meter with COB technology
• Efficiency of 80 lm/W
• Direct 220-240V power supply, no driver needed
• Maximum length of 50 m in series, IP65 rating
• Cut at designated marks, operating range from -20°C to +40°C

Features

• Length ordered to the exact meter, no leftover from the project
• Continuous blue light without dot effect on reflective surfaces
• No driver to size or install within the structure
• Additional adjustment possible at cutting marks during installation
• Approximate lifespan of 20,000 hours

Installation

Unroll the delivered length along the support, fix the strip with clips or in an aluminum profile, then connect the end to 220-240V. Additional cuts should only be made at the designated marks; seal the free end with a final cap to maintain IP65 protection. Observe the 50 m series limit. Work must be done with power off.

Where to Use This Blue COB Strip?

• Supplements and repairs on existing markings
• Short sections for facade highlighting
• Niches, returns, and isolated layout modules
• Models, prototypes, and concept validations
• Areas around pools and covered aquatic equipment