Red COB LED Strip Sold by the Meter, Length Adjusted to Measurement

Counter cladding, niche outlining, or scenography adjustments are priced per linear meter, not by packaging. Selling by the cut avoids tying up a reel for just a few meters and eliminates leftover material at the end of the project. The strip maintains its 296 LEDs per meter using COB (Chip On Board) technology for a dense and continuous red light, direct 220V power supply without a driver, and an IP65 rating.

Technical Details

• Light color: monochrome red
• 10W per linear meter, approximately 800 lm per meter
• 296 LEDs per meter with COB technology
• Efficiency of 80 lm/W
• Direct 220-240V power supply, no driver needed
• Maximum length of 50 m in series, IP65 rating
• Cuttable at marked points, operating range from -20°C to +40°C

Features

• Length ordered to the exact meter, no leftover material
• Dense and continuous red light output, no visible diode pattern
• No power block needed within the circuit
• Additional adjustment possible at cutting marks during installation
• Approximate lifespan of 20,000 hours

Installation

Unroll the delivered length along the support, fix the strip with clips or in an aluminum profile, then connect the end to 220-240V. Additional cuts should only be made at the designated marks; seal the free end with a final cap to maintain IP65 protection. Observe the 50 m series length limit. Work with power off.

Where to Use This Red COB Strip?

• Cladding counters and commercial furniture
• Adjustments and additions to existing scenography
• Outlining niches and fitting modules
• Studios, control rooms, and temporary installations
• Models and concept validations before deployment