Tunnel LED Strip 25M 2835 220V AC 9W/m IP65 120 LED/m - Linkable up to 250M

⚠️ The power cable is not included with this strip; it must be ordered separately.

220V tunnel LED strip, 25 m reel connectable up to 250 m

For long runs — utility galleries, parking lots, underground passageways — the challenge is not light output but power supply: installing an electrical connection every twenty meters costs more than the light fixture itself. This strip connects end to end for up to 250 m in series from a single 220V power supply point, with no driver and no power cable to run along the route. Its design alternates 1 m with LEDs and 1 m without LEDs, distributing light over the entire distance while keeping power consumption in check. The 25 m reel can be cut every meter, and its UV-resistant IP65 PVC sheath is suitable for damp and dusty environments.

Technical details

• 25 m reel, connectable up to 250 m from a single power supply point
• Alternating 1 m illuminated / 1 m without LEDs along the entire length
• Direct 220-240V power supply, with no driver or power supply unit
• 9W per illuminated meter, or 117W for the complete reel
• 120 LEDs per meter on illuminated sections, Ra 90
• IP65 protection rating (rain, dust)
• Can be cut every meter at the marked points
• Flexible, UV-resistant PVC sheath

Features

• A single power supply point for a 250 m run: fewer electrical connections to install
• No remote driver, so there is no box to house or maintain along the route
• Flexible enough to follow curves and structural contours
• Ra 90 for faithful reproduction of signage and markings
• Suitable for indoor and outdoor use thanks to its IP65 rating

Installation

Unroll the strip along the support and secure it with clips or in a profile, then connect the power connector to 220-240V. For long runs, connect multiple reels end to end, up to 250 m, before connecting them to a single power supply point. Cut only at the marked points, every meter, and seal the free end with an end cap. Disconnect power before installation.

Where should you use this tunnel LED strip?

• Tunnels, utility galleries and underground passageways
• Covered parking lots and traffic lanes
• Marking out walkways and maneuvering areas
• Facade, cornice and exterior structure underlining
• Construction sites, site facilities and temporary installations