50M Flexible LED Neon 360° 220V 9W/m IP65

50 m coil of flexible 360° LED neon for signs and signage

The round Ø 14 mm profile emits light around its entire circumference. Unlike a flat strip, its appearance remains the same from every viewing angle, which is essential for lettering viewed from the street or an outline viewed obliquely. The flexible body can be shaped into letters, logos and tight curves without special tools, while the direct 220V power supply eliminates the driver and its enclosure—a key benefit when there is no room for technical equipment. The 50 m coil covers an entire installation, with cutting at the designated marks and IP65 protection for outdoor use.

Technical details

• 9W per meter, or 450W for the 50 m coil
• Round Ø 14 mm profile with 360° light emission
• 240 LEDs per meter, luminous flux of approximately 580 lm per meter
• Color rendering Ra 90
• Direct 220-240V power supply, no driver required
• IP65 protection rating, suitable for outdoor use
• Cutting at the designated marks, operating range from -20°C to +40°C

Features

• 360° light emission: consistent appearance from every viewing angle
• Flexible bending at a tight radius for lettering, logos and outlines
• Ra 90 color rendering, suitable for commercial façades and storefronts
• No driver or technical enclosure to install
• IP65 waterproof sheath for permanent outdoor exposure

Installation

Mark out the layout on the mounting surface, secure the neon using the dedicated clips, spacing them closer together around curves, then connect the end cap to the 220-240V supply. Cut only at the designated marks; seal the open end with an end cap to maintain waterproofing. Disconnect the power before installation.

Where can you use this flexible LED neon?

• Storefront signs, illuminated lettering and logos
• Commercial signage and façade identification
• Structural outlines, ramps and railings
• Terraces, pergolas and outdoor hospitality venues
• Event decorations and short-term stage designs