5M 24V IP20 320LED/m COB LED Strip - Green
On a commercial project, green is used as much for guidance as for decoration. This 5-metre reel delivers 8 W per metre with a density of 320 COB chips, producing a perfectly even green strip without the visible grain of conventional SMD strips.
Technical details
- Density: 320 LEDs/m — COB (Chip On Board) technology
- 8 W/m — 40 W for the 5 m reel
- 3600 lm total, 720 lm/m, 90 lm/W
- Incandescent equivalent: 400 W
- 24V DC (SELV) — transformer power supply required
- 120° angle — CRI Ra 80 — dimmable
- IP20 — dry locations
- 500 x 0.79 cm — can be cut every 5 cm
- -20°C to +50°C — ~25000h — CE & RoHs — 2 years
Features
Because a monochrome green chip is more efficient than a filtered white LED, power consumption remains low while perceived brightness stays high. The strip supports 24V PWM (Pulse Width Modulation) control and retains its hue down to very low dimming levels, making it suitable for continuous standby mode.
The flexible printed circuit can be bent lengthwise to follow a curve, a stair nosing or a counter outline, without putting strain on the cut zones.
Installation
Switch off and lock out the main power supply. The 24V transformer must be sized with a 20% margin, or at least 48 W for the entire reel. Run sections in parallel from the injection point to control voltage drop. Check the transformer's protection rating according to the room where it is installed.
Direct bonding is suitable for smooth, clean surfaces; for heavy-duty use or in an accessible area, choose an aluminium profile with a diffuser, which protects the circuit and improves heat dissipation.
Where can you use this LED strip?
Workshop or utility-room traffic guidance, supplementary lighting for a service staircase, highlighting a living wall in a reception area, zone signage in a logistics warehouse. For dry locations only: for a damp or outdoor area, specify at least IP65.
